e3baroinputworkaround
Differences
This shows you the differences between two versions of the page.
|
e3baroinputworkaround [2009/09/22 14:53] twdorris created |
e3baroinputworkaround [2024/03/15 11:16] (current) |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| If you're really looking to maximize inputs, you can consider removing R27 from the topside of the ECU board. Best to use a couple small-tip soldering irons for this. Heat 'em up, apply one to each side of the resistor and slide it right off. I'm including a picture of the location of the resistor of interest below. Once you have done that, you can use either the baro or the intake air temp inputs for whatever you want. | If you're really looking to maximize inputs, you can consider removing R27 from the topside of the ECU board. Best to use a couple small-tip soldering irons for this. Heat 'em up, apply one to each side of the resistor and slide it right off. I'm including a picture of the location of the resistor of interest below. Once you have done that, you can use either the baro or the intake air temp inputs for whatever you want. | ||
| - | {{http://www.dsmlink.com/images/forums/e3baro.jpg}} | + | {{https://www.ecmtuning.com/images/forums/e3baro.jpg}} |
e3baroinputworkaround.txt ยท Last modified: 2024/03/15 11:16 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
