This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
ecuwiringinformation [2009/03/06 08:55] twdorris |
ecuwiringinformation [2010/02/05 11:24] twdorris |
||
---|---|---|---|
Line 24: | Line 24: | ||
http://www.dsmlink.com/images/forums/2GECUMFI.pdf | http://www.dsmlink.com/images/forums/2GECUMFI.pdf | ||
+ | |||
+ | |||
+ | ====== EVO1-3 ECU/MFI ====== | ||
+ | |||
+ | The document linked to below contains pin numbers and wire colors for the Lancer EVO1-3 ECU connector. This document was provided by the kind folks at [[http://www.evocoupe.net/forum/|evocoupe.net]]. | ||
+ | |||
+ | http://www.ecmtuning.com/images/forums/EVO1-3ECUPinout.pdf | ||
+ | |||
+ | The following is a copy of the MFI wiring schematic taken from Mitsubishi's own shop manual documentation. Provided here for references purposes only. | ||
+ | |||
+ | **NOTE:** The MFI circuit diagram below is NOT the EVO1-3 diagram. I've searched LONG and HARD for the EVO1-3 circuit diagrams, but have failed to find them *anywhere*. I've even asked a couple guys over in Japan to source them, but everything has fallen through. So we're left with EVO4 diagrams which closely match the EVO1-3 with the exception that there's an extra connector and that pins 71-92 in the EVO4 diagrams should be remapped to 51-72 to match up with the ECU pin out provided above. | ||
+ | |||
+ | http://www.ecmtuning.com/images/forums/EVO4MFI.pdf | ||
+ | |||
+ | If anybody can source the TRUE Japanese EVO1-3 shop manuals with circuit diagrams, the entire rest of the world would appreciate it! As far as I can tell, nobody has these. |