This shows you the differences between two versions of the page.
Next revision Both sides next revision | |||
ethadapter1g [2014/05/21 13:32] twdorris created |
ethadapter1g [2014/05/21 13:46] twdorris |
||
---|---|---|---|
Line 5: | Line 5: | ||
- | The adapter we provide to connect an ethanol sensor directly to our SD cable has two free pins that need to be installed into the MAF connector end of the SD cable. For a 1G-style MAF connector, you must first remove the orange locking tab. This is done by simply prying on the small hole in the locking tab using the connector housing as your leverage point. Then you simply push the pins (and seals) into place and reinstall the locking tab. | + | The adapter we provide to connect an ethanol sensor directly to our SD cable has two free pins that need to be installed into the MAF connector end of the SD cable. For a 1G-style MAF connector, you must first remove the orange locking tab. This is done by simply prying on the small hole in the locking tab using the connector housing as your leverage point. Then you simply push the pins (and seals) into place and reinstall the locking tab. |
- | | {{:ethanolsensor:eth2g-pin-insert.png?direct&161x200}} | {{:ethanolsensor:eth2g-pin-done.png?nolink&118x200}} | | + | | {{:ethanolsensor:eth1g-lockingtab.png?direct&254x200}} | {{:ethanolsensor:eth1g-pin-insert.png?direct&108x200}} | {{:ethanolsensor:eth1g-pin-done.png?direct&89x200}} | |
- | | **(click to enlarge)** | **(click to enlarge)** | | + | | | **(click to enlarge)** | **(click to enlarge)** | |