gmmafcablemod
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
gmmafcablemod [2009/06/08 10:10] twdorris created |
gmmafcablemod [2009/06/08 15:14] dmertz |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| To correct this problem, we suggest the following modification. It's really very simple. You are just going to power the GM MAF sensor off chassis ground instead of sensor ground. | To correct this problem, we suggest the following modification. It's really very simple. You are just going to power the GM MAF sensor off chassis ground instead of sensor ground. | ||
| + | |||
| ===== Cut the GM MAF Ground Wire ===== | ===== Cut the GM MAF Ground Wire ===== | ||
| Line 17: | Line 18: | ||
| {{http://www.ecmtuning.com/images/forums/mafgndcut.jpg}} | {{http://www.ecmtuning.com/images/forums/mafgndcut.jpg}} | ||
| - | Done | + | |
| + | |||
| + | ===== Extend the Wire to the Firewall ===== | ||
| + | The next step should be obvious. Just solder an extension wire onto the exposed end of the GM MAF ground wire and run it over to a chassis ground point. We do this with a standard ring terminal as illustrated below. Of course, as always, be sure to heatshrink the solder joint. It would also be a good idea to put a zip-tie around the three wires to the GM MAF connector to provide strain relief for the new wire... | ||
| + | |||
| + | {{ http://www.ecmtuning.com/images/forums/ringterminal.jpg }} | ||
gmmafcablemod.txt · Last modified: 2024/03/15 11:16 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
