This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
howto [2008/01/23 06:25] 76.100.119.159 |
howto [2008/01/23 09:24] 76.100.119.159 |
||
---|---|---|---|
Line 4: | Line 4: | ||
===== Hardware ===== | ===== Hardware ===== | ||
- | * SwapPlugWires | + | * [[SwapPlugWires|2G plug wire swap]] - Installing DSMLink in a car without a '95/'96 style cam angle sensor |
- | * 90ClutchCut | + | * [[90ClutchCut|Clutch cut wire on a '90 DSM]] - Installing a clutch cut (NLTS) wire in a 1990 DSM |
- | * NitrousControlDetails | + | * [[NitrousControlWiring|Basic "nitrous" controls]] - The basics of wiring up a solenoid to be control by DSMLink's "nitrous" controls |
- | * NitrousControlWiring | + | * [[NitrousControlDetails|"Nitrous" control specifics]] - More specific information about DSMLink's control of the FPR solenoid output |
- | * UseNitrousControlsForDejonToolBOVMod | + | * [[UseNitrousControlsForDejonToolBOVMod|"Nitrous" control used for BOV bypass mod]] - Describes one alternative use of DSMLink's "nitrous" controls |
* [[InstallNewSensor|Install a sensor for datalogging]] - Describes how to use a non-factory sensor for datalogging (e.g., a boost sensor, a wideband kit, etc.) | * [[InstallNewSensor|Install a sensor for datalogging]] - Describes how to use a non-factory sensor for datalogging (e.g., a boost sensor, a wideband kit, etc.) | ||
===== Tuning/dial-in ===== | ===== Tuning/dial-in ===== | ||
- | * MAFTCalibrationByWBO2 | + | * [[MAFTCalibrationByWBO2|MAFT Calibration using a WBO2]] - Describes how to calibrate a MAFT output using a WBO2 |
- | * MAFTCalibrationByLoggedBoost | + | * [[MAFTCalibrationByLoggedBoost|MAFT Calibration using a boost sensor]] - Describes how to calibrate a MAFT output using a boost sensor |
- | * CreateVolumetricEfficiencyMap | + | * [[CreateVolumetricEfficiencyMap|Customize the VE table for your setup]] - Create a VE table more suited to your specific setup |
- | * 2GTimingIn1GECU | + | * [[2GTimingIn1GECU|Settings to run 2G timing in a 1G]] |
- | * DSMLinkTPSAdjustment | + | * [[DSMLinkTPSAdjustment|How to dial in TPS/idle switch]] |
===== Alternate OS'es ===== | ===== Alternate OS'es ===== | ||
- | * LinuxInstall | + | * [[LinuxInstall|Linux install]] |
- | * MacOSInstall | + | * [[MacOSInstall|MacOS install]] |
- | * PocketPCInstall | + | * [[PocketPCInstall|PocketPC install]] |
+ | * [[PalmInstall|Palm install]] | ||