User Tools

Site Tools


injdata-overview

This is an old revision of the document!


Injector data - Overview

Injectors are thought of as simple devices. You grab a set of XYZ injectors off someone's website, adjust your global fuel scale and deadtime tables based on what they told you the injectors flowed and drive off. But if you've actually tried this, you probably already know it doesn't always work out that way.

This page is intended to explain why it's just not that easy and to explain why the services we provide can help, at least a little bit and at least with Mitsubishi ECUs.

It's also intended as a reality check to some extent as to what's physically possible and what's not.

What are "the numbers"?

Let's start with a quick explanation of “the numbers”. Most factory ECUs model injector flowrate as a simple linear (straight line) approximation. If we plot out the measured flow rate of a stock set of DSM injectors and then show the linear approximation on top of it, you'll see why. The two line up extremely well.

Basic injector numbers
Click to enlarge

The slope of this line indicates basic injector flow rate. Larger injectors will have a steeper slope. Meaning you get a larger increase in flowrate (y-axis or “rise”) for each increase in injector pulsewidth (x-axis or “run”).

Where this approximation line crosses the x-axis is what we call “deadtime”. That's the point of estimated “zero” flow (y-axis value of 0 cc/min). It gets tricky, though, because this “deadtime” number is entirely abstract. It doesn't really represent the zero flow point of the injector. It's just the offset used to make the approximation line a “best fit” to the measured data. The image below illustrates this idea.

Injector deadtime example
Click to enlarge

Getting the right numbers

Flow testing injectors is not easy. Well, it's easy to grab basic flow data and post it up. But it's not easy to drill down into the details that really affect idle and part throttle driveability and figuring out why one set of injectors on one car seems to behave so different than another set of the same type of injectors on another car.

Nobody in the aftermarket community does this right for everyone and we're not claiming to be the exception. The whole problem is just too large and the operating environment (your car) is just too uncontrolled.

The best we can do here is to explain many of the things that make the process difficult and to explain what we do above and beyond to get you a lot closer out of the gate.

First, let's review some of the things that make getting exact numbers for your exact situation really hard.

  1. Low pulsewidth variation from one injector to the next is common (click to read)
  2. Different injector driver circuits produce different results (click to read)
  3. Fuel pressure affects deadtime as much as flow rate (click to read)
  4. Voltage offset tables need to be customized (click to read)
  5. Even fuel viscosity plays a role (click to read)
injdata-overview.1323870222.txt.gz · Last modified: 2011/12/14 08:43 by twdorris