This is an old revision of the document!
Installation of the Innovate LC-1 wideband kit is pretty straight forward. The LC-1 Installation manual covers most of the basics for a general install. We do, however, have a few specific suggestions and one grounding correction below.
The following is provided for reference in the sections that follow. You can also get detailed pin out information off our ECU wiring page.
LC-1 wire | Description | Typical install point |
---|---|---|
Red | 12V supply | Switched +12V source, fused |
Blue | Heater Ground | Chassis ground lug |
White | System Ground | ECU's sensor ground |
Yellow | Analog out 1 | Unused |
Brown | Analog out 2 | Selected ECU input |
Black | Calibration wire | Wired according to LC-1 notes |
The red wire typically goes to a switched +12v source. Off the ECU connector,