lc1install
This is an old revision of the document!
Table of Contents
Recommended Innovate LC-1 Installation
Installation of the Innovate LC-1 wideband kit is pretty straight forward. The LC-1 Installation manual covers most of the basics for a general install. We do, however, have a few specific suggestions and one grounding correction below.
ECU wires
The following is provided for reference in the sections that follow. You can also get detailed pin out information off our ECU wiring page.
| ECU | Connectors (viewed with male pins pointing out towards you |
|---|---|
| 1G DSM |  |
| 2G DSM |  |
Basic LC-1 wire assignments
| LC-1 wire | Description | Typical install point | 1G DSM | 2G DSM |
|---|---|---|---|---|
| Red | 12V supply | Switched +12V source, fused | 102 or 107 | 12 or 25 |
| Blue | Heater Ground | Chassis ground lug | 101 or 106 | 13 or 26 |
| White | System Ground | ECU's sensor ground | 24 | 92 |
| Yellow | Analog out 1 | Unused | N/A | N/A |
| Brown | Analog out 2 | Selected ECU input | 4 (or 15, 16) | 76 (or 73, 75, 85) |
| Black | Calibration wire | Wired according to LC-1 notes | N/A | N/A |
RED wire - notes
The red wire typically goes to a switched +12v source. Off the ECU connector,
lc1install.1331674395.txt.gz · Last modified: 2012/03/13 17:33 by twdorris
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
