This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
linearitems [2009/06/05 07:37] twdorris |
linearitems [2009/06/05 07:40] twdorris |
||
---|---|---|---|
Line 14: | Line 14: | ||
Once you have that information ready to go, you basically just assign the input (as mentioned above), then add the new item to your datalogging stream using the Captured values (F10) dialog and start a new datalog (F11). After that, you can add the new item for display on the screen using the Display values (F9) dialog. | Once you have that information ready to go, you basically just assign the input (as mentioned above), then add the new item to your datalogging stream using the Captured values (F10) dialog and start a new datalog (F11). After that, you can add the new item for display on the screen using the Display values (F9) dialog. | ||
- | At this point, you should have a screen that looks something like the one below: | + | At this point, you should have a screen that looks something like the one below (click to enlarge). The screen below shows an example using the linear boost "sensor". |
{{ http://www.ecmtuning.com/images/forums/v3screenshots/linboost.png?294x197 }} | {{ http://www.ecmtuning.com/images/forums/v3screenshots/linboost.png?294x197 }} | ||
+ | If you right click on the LinBoost item and select preferences, you'll get a dialog where you can configure the boost sensor's properties. This will look something like the following: | ||
+ | {{ http://www.ecmtuning.com/images/forums/v3screenshots/linboostprefs.png }} |