User Tools

Site Tools


nonepromprocess2g

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
nonepromprocess2g [2016/09/23 14:40]
twdorris [Initial Non-EPROM Board]
nonepromprocess2g [2024/03/15 11:16] (current)
Line 14: Line 14:
  
  
-{{:​noneprom2gbefore.jpg?​direct&​296x236 ​ }}+|{{:​noneprom2gbefore.jpg?​direct&​296x236 ​ }} |
  
 ===== CPU Removed ===== ===== CPU Removed =====
Line 22: Line 22:
  
  
-{{http://​www.ecmtuning.com/​images/​forums/​ecurepair/​noneprom-nocpu.jpg?direct&350x280 ​ }} +|{{:noneprom2gafter.jpg?nolink&267x190 ​ ​}} ​|
  
 ===== Adapter Plug ===== ===== Adapter Plug =====
  
  
-After the CPU is removed, we have to install an adapter plug in its place. The following picture shows a board after this step is complete ​(click to enlarge). Note the careful solder work involved on those pins.+After the CPU is removed, we have to install an adapter plug in its place (left picture). We do not make this plug, but we do pay dearly for it! Note the careful solder work involved on those castellations (side pads) on the adapter board. 
  
 +And better yet, look at the work required to build that mating piece in the picture on the right! Those are hand built with 100 pins spaced about as closely as you can. It's hard to get anyone willing to even make the piece those pins fit into with such tight tolerances much less install and solder all 100 pins!
  
-{{http://​www.ecmtuning.com/​images/​forums/​ecurepair/​noneprom-plug.jpg?​direct&​350x280 ​ }} 
  
 +|{{:​qfp100base.jpg?​nolink&​289x212 ​ }} |{{:​qfp100mate.jpg?​nolink&​289x212}} |
  
 ===== Finished Product ===== ===== Finished Product =====
  
  
-The final step is to snap our specially designed conversion board into place. The following picture shows the finished result (click to enlarge).+The final step is to snap our specially designed conversion board into place. The following picture shows the finished result (click to enlarge). Note the machined mounting bar and machined spacers used to secure the board in place using the mounting points provided in the factory ECU case bottom. There is a LOT of manual, custom work done to produce these boards.
  
  
-{{http://​www.ecmtuning.com/​images/​forums/​ecurepair/​noneprom-done.jpg?direct&350x280 ​ }}+|{{:2gnoneprom2.jpg?nolink&281x212 ​ ​}} ​|
  
nonepromprocess2g.1474656037.txt.gz · Last modified: 2016/09/23 14:40 by twdorris