prodcompare
This is an old revision of the document!
| V3Lite | FullV3 | Description | |
|---|---|---|---|
| Greatly enhanced logging | ✔ | ✔ | Logging speeds in excess of 1000 samples per second, logging far more data than is available in the factory interface. |
| Global injector compensation | ✔ | ✔ | |
| Injector deadtime control | ✔ | ✔ | |
| Extended fuel and timing tables | |||
| 8000 RPM & 23psi | ✔ | ||
| 10000 RPM & 35psi | ✔ | ||
| Speed Density | You can run outside these ranges. You just won't have individual adjustment points. | ||
| 8000 RPM & 26psi | ✔ | ||
| 10000 RPM & 40psi | ✔ | ||
| Airflow compensation | ✔ | ✔ | |
| Selectable Mitsubishi MAS | ✔ | ✔ | |
| MAP sampling relative to crank position | ✔ | ✔ | |
| Engine speed limits (rev, launch, NLTS, etc.) | ✔ | ✔ | |
| Torque calculation inside the ECU | ✔ | ✔ | |
| Dash gauge display | ✔ | ✔ | |
| TPS adjustments/dial-in | ✔ | ✔ | |
| Idle switch simulation | ✔ | ✔ | |
| Narrowband O2 simulation | ✔ | ✔ | |
| Anti-lag | ✔ | ✔ | |
| Knock sensor control | ✔ | ✔ | |
| Solenoid tests | ✔ | ✔ | |
| Fan control, fuel pump control, etc. | ✔ | ✔ | |
| DTCs (check engine codes) | ✔ | ✔ | |
| Log aftermarket sensors | ✔ | ✔ | |
| O2 feedback control | ✔ | ✔ | |
| Throttle tip-in adjustments | ✔ | ✔ | |
| Airflow smoothing | ✔ | ✔ | |
| Long-term fuel trim control points | ✔ | ✔ | |
| Open loop thresholds | ✔ | ✔ | |
| Native GM MAF support | ✔ | ||
| Switchable secondary maps | ✔ | ||
| Secondary fuel (more than 4 injectors) | ✔ | ||
| Output controls (nitrous, water injection, etc.) | ✔ | ||
| Auto-scaled, RPM-based fuel adjustments | ✔ | ||
| Simplified RPM-based timing controls | ✔ | ||
| Idle air simulation | ✔ |
prodcompare.1263417133.txt.gz · Last modified: 2010/01/13 16:12 by twdorris
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
