v3hardreset
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
v3hardreset [2009/02/04 07:42] twdorris created |
v3hardreset [2024/03/15 11:16] (current) |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| - Turn the ignition on (don't start the engine) | - Turn the ignition on (don't start the engine) | ||
| - Wait for the CEL light to go back off after a few seconds just as a check that the ECU is up and running normally. | - Wait for the CEL light to go back off after a few seconds just as a check that the ECU is up and running normally. | ||
| - | - Press the throttle to the floor and keep it there as you cycle the ignition key off and then back on 3 or 4 times. I usually go for 4 but 3 is the minimum. Pause for just a moment between on/off switches (like about a 1-second pause). | + | - Press the throttle to the floor and keep it there as you cycle the ignition key off and then back on 3 or 4 times. I usually go for 4 but 3 is the minimum. Pause for just a moment between on/off switches (about a 0.5-second pause, but not more than 1.5 seconds). |
| Once you have done that, the ECU should reset back to the hard coded defaults in the chip. | Once you have done that, the ECU should reset back to the hard coded defaults in the chip. | ||
| + | |||
| + | |||
| + | Additional notes: | ||
| + | |||
| + | - The vehicle speed must be zero. | ||
| + | - ThrotPos must exceed 72%. (Verify by logging.) | ||
| + | - Beginning with the ignition on but the engine not running, the minimum sequence is: turn the key off (first time) for 1/2 second, on for 1/2 second, off (second time) for 1/2 second, on for 1/2 second, off (third time) for 1/2 second, then on and leave on. (The speed of the off-on should be about like a clock going tick-tock or a bit faster. Failure to reset usually is caused by toggling the key too slowly.) | ||
| + | - If you initiate logging prior to performing the reset sequence, the logging will halt (the seconds counter will stop updating) the instant the reset happens. | ||
| + | - With firmware v3.18.205 or earlier in the ECU, to be sure that the default settings are properly saved after executing the hard-boot procedure, use the PC app to modify any configuration value and Save to ECU before shutting off the ignition. | ||
v3hardreset.1233751338.txt.gz ยท Last modified: 2009/02/04 07:42 by twdorris
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
