v3mafadjcombft
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
v3mafadjcombft [2009/06/11 14:09] twdorris |
v3mafadjcombft [2009/06/11 14:11] twdorris |
||
|---|---|---|---|
| Line 10: | Line 10: | ||
| You absolutely MUST make sure your fuel settings are already appropriate for your injector size, fuel type and base fuel pressure. If there is any deviation here, then the adjustments to airflow suggested by this function will simply include those fuel corrections as well! This can create a really confusing configuration if you aren't careful. So please review your [[baseinjectordata|global fuel and deadtime settings]] first to make sure they are at least somewhat reasonable for your setup. | You absolutely MUST make sure your fuel settings are already appropriate for your injector size, fuel type and base fuel pressure. If there is any deviation here, then the adjustments to airflow suggested by this function will simply include those fuel corrections as well! This can create a really confusing configuration if you aren't careful. So please review your [[baseinjectordata|global fuel and deadtime settings]] first to make sure they are at least somewhat reasonable for your setup. | ||
| - | ====== STEP 2: Check For Close Loop Operation ====== | + | |
| + | ====== STEP 2: Check For Closed Loop Operation ====== | ||
| Make sure the car is able to run in closed loop mode. Look for a cycling FrontO2 sensor and a "1" in the ClosedLoop log item. It doesn't have to be running with fuel trims near 0% (that's the purpose of using this function after all). But it does need to at least cycle in closed loop mode on its own. If it does not, you need to make some manual adjustments first to at least get it running in closed loop. | Make sure the car is able to run in closed loop mode. Look for a cycling FrontO2 sensor and a "1" in the ClosedLoop log item. It doesn't have to be running with fuel trims near 0% (that's the purpose of using this function after all). But it does need to at least cycle in closed loop mode on its own. If it does not, you need to make some manual adjustments first to at least get it running in closed loop. | ||
v3mafadjcombft.txt · Last modified: 2024/03/15 11:16 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
